- Miter Saw (10" or 12")
A Miter Saw is a big purchase. It's not critical to the build but the accuracy and quality of the
cut
is much better for a DIY'er and is safer in my opinion. You can make do with a Circular Saw or even
a
Hand Saw. I would get at least a 10" and I personally would go for a corded model.
- Drill/Driver Combo
If money is tight, I would get a corded, variable speed drill. It may very well last a lifetime of
DIY use.
Batteries are expensive and they WILL eventually die.
- Tape Measure (16ft or 5m)
16 feet or 5 meters is in the middle. These are a bit easier to read and a bit more Heavy Duty.
- 12" Combination Square
A Combination Square serves many functions. Good for Layout and getting things square. You could
also
use a 6" Speed Square but I recommend a 12 inch Combination Square.
- 1/2" (13mm) Drill Bit (For Bolt Holes)
Make sure it adapts to your Drill/Driver of choice. If you can get one 3 inches long, great, but we
can
make shorter work. A Brad Point Bit works best for wood. Twist Bits will work but are not
ideal for wood. Make sure if you buy a drill set, it has a 1/2" Bit. Some do some don't.
- 3/16" (5mm) Drill Bit (For Pilot Holes)
Make sure it fits your Drill/Driver of choice. You can get a Counter Sink Bit but it's really not
necessary for this build. Again Brad Point is best for wood.
It's better to buy a set here, you usually get more for your money and you will eventually need
other sizes.
- Driver Bit(s)
You need Driver Bits that fit your chosen Drill/Driver & Screws. It's better to buy a set here as
well.
- Wrenches to fit NUTS and BOLTS
You need 3/4" SAE for standard.